Greetings all, On page NP.21.13 of the FCOM, I am following the procedure to test the Fire Control panel. When I hold the Test switch to FAULT/INOP, I don't get the illumination of the OVHT/DET light nor the FAULT light. In fact, I get no annuciations. When I move the switch to OVHT/FIRE I get the Fire Warning light, the bell, and the OVHT/DET annunciator...so all is good there. I can verify the annuciator light bulbs are good as I have tested all lights with the test switch. I have loaded the panel from Cold and Dark state, and I have also made sure that there are no FAILURES active in the FMC setup menu, and have cleared any service based failures (actually OFF). Any ideas? Thanks, Jason BeallAlberta, Canada See my YouTube page if you are interested in the Cessna 310: www.youtube.com/flyboy98

I'm sorry to be mean, but I just burst out laughing when I read this. Perhaps others will see the humour too. Patrick Wellen