Hi guys,For a few days I am encountering some strange trouble concerning mouse using within VC :Two examples : 1) The easy-to-use click spot for deploying HGS becomes hard to use : When I pass the mouse to the support post in order to lower the HGS, I can't see anymore the little hand cursor without pressing the left button of the mouse, and it becomes hard to get the HGS out, or to upper it once deployed.2) When I pass the mouse onto the course button to the MCP, same problem, nothing appears. I have to press the left mouse button, and even with that I only just can increase the course number and not decrease it .Everything goes well within 2D panel. I recently bought the registered version of FSUIPC and just calibated my throttle with it. I read into the introduction manual that some users had experienced trouble while calibrating hardware through FSUIPC.(I did that because my X52 throttle (non pro version), had a too hight idle rate). I don't think there is a connexion with my mouse problem however. Any idea of this problem ?Thank's jc

Hi again, Problem seems solved! that was a FSUIPC calibration issue.Indeed, I made the error of validating all the calibration commands (mixtures, spoilers etc..), instead of only calibrate main flight controls and brakes.CheersJc