jcmic

Hi again, Problem seems solved! that was a FSUIPC calibration issue.Indeed, I made the error of validating all the calibration commands (mixtures, spoilers etc..), instead of only calibrate main flight controls and brakes.CheersJc

Hi guys,For a few days I am encountering some strange trouble concerning mouse using within VC :Two examples : 1) The easy-to-use click spot for deploying HGS becomes hard to use : When I pass the mouse to the support post in order to lower the HGS, I can't see anymore the little hand cursor without pressing the left button of the mouse, and it becomes hard to get the HGS out, or to upper it once deployed.2) When I pass the mouse onto the course button to the MCP, same problem, nothing appears. I have to press the left mouse button, and even with that I only just can increase the course number and not decrease it .Everything goes well within 2D panel. I recently bought the registered version of FSUIPC and just calibated my throttle with it. I read into the introduction manual that some users had experienced trouble while calibrating hardware through FSUIPC.(I did that because my X52 throttle (non pro version), had a too hight idle rate). I don't think there is a connexion with my mouse problem however. Any idea of this problem ?Thank's jc

Thanks to all of you, I'v actually noticed that shortcuts commands within CDU PMDG setup->options->Key commands have the lead onto MS assignation menu, even if they are cleared.Then, I am going to study your solutions. Regards Jc Michel

Hi everyone, I am very satisfied of this great plane until now, as far as I could experience it on many flights.Just a little problem, concerning my joystick Saitek X52 on which I 'd like to associate the button n°2 to the cmd A on the MCP.I have well made the association trought FSX menu and it works on the other planes (basics or addons).But with 737NGX nothing happen when I pres the n°2 joystick button.Did I miss something ? By advance, Thanks for clarification Jc MichelMoreover, I have to say that this button should works as the Z key of the keypad. (And the Z key works well as it press the cmd A command)