Hi, I just recently purchased the J41. I think it's a great product. It really shows that a lot of effort has gone into designing this plane :-) Yesterday I started going through the tutorial. It was getting late so after I finished the preflight section I saved the flight. Today I loaded the flight and I discovered that the ramp manager state was not in the same state as when I saved the flight yesterday. The GPU was not enabled so the cockpit was pretty much dead. Also the landing elevation has a different value than the one I put in yesterday. I realize this may be a side effect of the GPU being disconnected. I guess I better do the preflight check from the beginning to ensure the aircraft is in the correct state. My question is: Is there any way to save the ramp manager state along with the flight or is that just a no go? I can live with that, I would just like to know. Thanks for a quality product! Best regards,Lars

Hmm, I don't think so - It seems to default to the usual values every time I load. There must be an .cfg or .ini files somewhere where we can manually change the default values...I'll take a look later on.