Jump to content

Archived

This topic is now archived and is closed to further replies.

twowolves

shockwave lights?

Recommended Posts

Hi.Is there someone out there who could do shockwave lights for the CT210M.That would be outstanding if one of you good people could.

Share this post


Link to post
Share on other sites

HiBelow are the entries I have been playing around with for the 210, I have left the strobes and beacon as standard as the strobes look pretty good to me as is, plus the shockwave beacons I have tried tend to show in the cockpit which can be a bit off putting, as for the landing lights I'm still deciding on those but the entry below should give you a starting point at least.light.0 = 2, -2.65, -18.20, 2.50, fx_strobecarcct,light.1 = 2, -2.90, 18.20, 2.50, fx_strobecarcct,light.2 = 1, -20.60, 0.00, 5.50, fx_beaconcarcct,light.3 = 4, -1.20, 0.00, 0.40, fx_vclightcarcct,light.4 = 10, -6.20, 0.00, 1.00, fx_vclightcarcct2,light.5 = 6, 4.35, -0.8, -1.25, fx_shockwave_landing_light_small_old // Shockwave lightlight.6 = 5, 4.35, 0.8, -1.25, fx_shockwave_landing_light_low_old // Shockwave light obviously don’t forget to add the following to the [Vcockpit01] section of the panel.cfg file gauge03=Shockwave_Lights!SW Lights, 245,187,8,12 I hope it helps. Jim Hodkinson

Share this post


Link to post
Share on other sites

Hi.Jim. Thank you for taking the time to do the lights for the CT210M.they look great.again thank you.Two Wolves

Share this post


Link to post
Share on other sites

×
×
  • Create New...