Hi ya all,Recently i have tried to make a ILS approach with NAV1 and NAV2.But on most of my panels i can't change the frequency COM, NAV1 and NAV2 they remain the same nr.or it does not even show up the NAV1 NAV2 and COM it's gone????? http://forums.avsim.net/user_files/66677.jpg-----------------------------------------------------------------or it does not even show up the NAV1 NAV2 and COM it's gone????? http://forums.avsim.net/user_files/66678.jpgI have the same old story it won't change so i can't make a ILS landing. The NAV and COM panel are in the main and (not a sidepanel shift-2)It only has a main panel and GPS.Can anyone help me please, I also re-installed fs2004 but still no luck.Regards,L.Jim

Hello,Are you using an English version of Windows XP? If not you need to change the decimal separator from being a , to a .I forget where you go to do this in WinXP but I'm sure someone else can come along tell you.Otherwise, you could have a look at the 'Aircraft.cfg' for this plane and I believe the Radios section should be like the following...// Radio Type=availiable, standby frequency, has glide slopeAudio.1=1Com.1= 1, 0Com.2= 1, 0Nav.1= 1, 0, 1Nav.2= 1, 0, 1Adf.1= 1Transponder.1= 1Marker.1= 1If yours looks like....// Radio Type=availiable, standby frequency, has glide slopeAudio.1=1Com.1= 1, 1Com.2= 1, 1Nav.1= 1, 1, 1Nav.2= 1, 1, 1Adf.1= 1Transponder.1= 1Marker.1= 1...then that's your problem and you should try editing your Aircraft.cfg Radios section to look my first example. I recommend you make a backup of your Aircraft.cfg file before editing it! Then in case anything goes wrong you can always put the original unedited one back.The second example indicates that the sim expects your radio tuner to have a 'Standby Frequency'. From your screenshot it looks like that first panel does not use the standby frequency for tuning the radio. I can't be certain about that second panel screenshot but it may very well not use a standby frequency either. If the second shot is of the Project Fokker 70/100 then there is a spot somewhere on there where you have to turn the radios on first before they will work and show anything there!Hope that helps,Jim

Hiya OneTinSoldier,Thank you for your reply. I just checked all the panels and indeed it's the , and . problem and it works. Great to see it go again. Also found the switch for the Fokker 70/100. It all seem to work just fine. I use the XP dutch version.Thank you agian for your rapid help. And also detailed info on it all. :) Regards,L.Jim

Hi Little Jim,Glad I was able help. And glad you were able to find where to change the decimal separator amd where to turn on the radios. :)Cheers,Jim