I have just started using FS Build and compiled a flight PLan and autogenerated etc and then went into PFE to compile etc.When I wanted to open up 'Define Oceanic Airspace for Selected ADV file' it just greyed out and would not open.

 

I then sent a message to Dave March,PFE Forum,and he told me to take out the co-ordinates i.e.6510N 5730N etc from the FS Build flight plan which I did,went back into PFE and the 'Define Oceanic Airspace' section opened as normal.

 

However,I do not have any co-ordinates in the flight plan and therefore I do not know where to put the start and end for the Atlantic Crossing.

 

I have sent another message to Dave March but I thought I would throw this open in case anyone may be able to assist me.

 

I thank you in anticipation.

I never used FSbuild but with FSC you can add NATracks to the flight plan and use those to define your oceanic airspace in PFE.