Hi,Just installed the latest Worthog, and where did the gear go? Stays in the up mode at all times.Layabout

More than likely, it was designed with the older FSDSv1 and the tool/process used for animations isn't supported in FS9, so they don't show.Did you get a warning when you tried to load it?? You say "latest", which one?Regards, MichaelKDFWhttp://www.calvirair.com/mcpics/PBTMCa.jpgCalVirAir International VACalVirAir International

Hi MichaelThanks for the reply. I got the file from that other site, and it appears to be a new paint, however, the entire aircraft is there. And yes, I got an install warning, which I did not pay much attention to, as the install directions indicated that this may happen, and was told to ignore it. To bad, as it is a nice aircraft, and a good panel.Bob