Hi there folks just thought i would ask around ive had my warthog since september and still havent really got much use out of it as i have a limited amount of time to get on never mind setting it all up.

 

So far i have managed to get all basic functions working such as throttle configured through FSUIPC etc but im needing help especially setting up the Reverse thrust detent on LINDA i have had it set in linda using the fsx reverser tab within the linda interface which technically works when i go over the detent the engines go into reverse but unlike when you press F2 the engines dont spool up into reverse thrust for some reason.

 

i have tried everything but cant seem to get the reversers to spool up when over the detent using linda.

 

if however i go into fsx controls and set the detent to the same command as F2 the reverse thrust do spool up how i want but the only problem i have is when i take off the detent obviously the engine puts a small amount of throttle back on causing a unsmooth transition from reverser to throttle idle

 

this is why i need this to get setup properly using linda as with linda i can setup (on release) engine throttle idle automatically which i cant currently do on fsx.

 

i will really need help here such as exactly how to do it step by step and will need the command line to use in linda.

 

thanks folks just wanting this all setup so when i fire up fsx and my concorde x im not sitting there thinking i wish this warthog was setup how i want it to work as currently its just killing the whole experience for me pictures would be fantastic.

 

have also read the Warthog tips and tricks but it hasn't helped me setup the reverse detent unfortunatley.

 

cheers

 

hayden

I only use FSUIPC for my Warthog setup, and it works fine. If you are still stuck msg me and I'll post my settings.