I have generated so far 2-3 flight plans with FSBuild (including SID/STAR as well as TOC/TOD) and import them into FMC of the 737NGX. Everything goes OK but when I arrive at the destination airport it never takes me to intercept the ILS of the generated runway. Am I doing something wrong? I was under the impression that FSBulid will take m to the generated runway.

 

 

and just another point in the Legs section, when the waypoint turns pink (magenta) do I adjust then the altitude shown on the right?

 

stelios

This is because the NGX does not use the saved SIDs/STARs. You have to manually put them in when you're doing your flight prep. There is a post about it by Tabs somwehere around.

 

Hope this helps