October 7, 201312 yr Hi, I am having problems with the nose wheel steering during taxiing and the take off roll ! As soon as I apply power the steering goes to maximum right lock without any inputs from me. Then after a few seconds the steering will centre again before repeating the process again. I don't know if it had anything to do with it, but I did try to do turns while going through the push back. the contols I used where...SHIFT + P then SHIFT +P + 1 & 2 . Can anyone provide me with a solution to this problem. Thanks in anticipation Aerovan.
October 8, 201312 yr Recalibrate your joystick/yoke, and make sure that the throttle control controls only the throttle? Tom Gibson CalClassic Propliner Page
October 10, 201312 yr Author Hi Tom, Thanks for the response. Yes I did think it could be a controller problem, and I went through the calibration wizard. Everything checked out ok....apart from the Z Axis input Bar on the calibration screen. No matter what I pressed it didn't move ? As I've never had this problem before, I can't remember if it ever did move ! However, when I press the FLY NOW button , and the aircraft is ready to go...I notice the front gear moving on its own without any inputs from me at all ! Usually when I get the aircraft moving...providing the throttles are equally set...the aircraft will simply go in a straight line. I have been busy with work at the moment, but will have another go at it soon. Regards Aerovan(Alan)
Create an account or sign in to comment