Hi,

 

Is there any harm in setting the texture and mesh sizes to the max even though the objects may not be at that resolution?

I think on FSX I always left the maxed.

 

Regards

Bob

I don't think any harm comes from it. I run mesh at 5m as that is the resolution of the finest mesh I use, and I don't see the point in changing it if flying somewhere that uses less fine elevation data.

 

With FSX there was also some thinking that running a higher scenery texture res forced the priority of the scenery loader, resulting in less blurries with photoscenery... whether that is the case with P3D is not known, but again I leave mine at 30cm, which is one step higher than the 60cm scenery I use.