FSX 'Ghosting' or Double image

I am having the same exact problem as this guy was here http://forum.avsim.net/topic/378536-pan-in-vc-produces-double-image-or-ghosting/

"Hello All,

Having updated my system performance is good, except for one little problem that drives me nuts: when panning in the VC (actually also spot view) the image seems to be drawn twice which especially seems to blur my cockpit. Best way to test for me: open the default flight and in the ultralight and look sideways that the red wires connected to the handle bar: when panning the wires seem to blur and go as wide as the pan movement between 2 frames. When stopping panning the wires are sharp and narrow again.
Since I use TrackIr this effeft has become a nuisance as the frequent movement gives me an 'out of focus' sensation.

I've been searching this and other forums, where most sollutions point to improving the performance of my machine, but that is, verified, no problem.

For a while I even thought my screen was interlacing, but that does not seem to be the case. I've played with all kinds of camera settings, frame limiters etc. but I keep coming down to that when panning, the frames seem to be half the old position and half the new position wich is a kind of motion blur. (higer frame rates make the effect smaller, but it's still there).

Any tips would be much appreciated."

Just finished building my dream machine i7-4970k & EVGA GTX 780 Ti SC and the performance is fantastic in DX 9, but I get OOM errors way to quickly. Recently switched to DX 10 and it is very smooth, but has microstutters. Not in the 2 second intervals, but constantly, especially when using TrackIR to pan very slowly.

Any help would be very much appreciated!!

Thank you,

Andrew P