CH Throttle Quad Problem

[burm 3]

I have a number of addon planes,PMDG,Majestic Software, etc.

I had my controller unchecked in fsx as I have all configured with fsuipc, everything going well...until.

I purchased the flight1 kingair.

I was having problems with the throttles so I reverted back to fsx control but still could not get them working so I parked this plane for now.

I unchecked controller in fsx but have new problems.

Only 4 lever out of 6 are working correctly on my CH throttle quad.

These 2 levers when pushed slightly forward in fsuipc axis  and calibration jump from the lowest minus number to the highest + number,

therefore causing the fsx plane lever to jump from idle to maximum.

I tried deleting the fsuipc.ini and no improvement.

I recalibrated using the ch control manager and they seem to be fine.

Would appreciate some help.

thanks

Paul