Hi.

 I purchased a cockpit Phd MCP (Ultra I believe)  from a fellow in Az. I cannot for the life of me figure out how to program this thing as I can't get it to run with sioc or fuipc. It came with zero documentation and no software so I am running blind on this.

 I checked the manufacturer and it looks like they have stopped selling these.

 I have put in a support request but no answer so far.

 Is there anyone out there who could help me out, either with a copy of the software or help programming the bugger.       Thanks guys.

Hi,

 

Have you got your MCP to work OK?

 

Have you tested the hardware with the SIOC.exe / SIOCMonitor program to see if switches and LEDS/displays work OK.

 

WHat type of aiplane are you going to use? PMDG ? or just the default FSX B737?

 

If you wanna use PMDG B737 you should go for OC4BA driver to get it working.

 

 

Hi. Thanks for the reply! I have since found out that the mcp/efis are knockoffs sold by a Chinese guy over at mycockpit.org. I have tested them in the sioc monitor and they seem to work, I.e. all the lights and switches work, but when I try to setup the program to run them they do not show up in either fsuipc or sioc. I am running fsx boxed with acceleration and ifly737ng. Thanks.

As you are running iFly 737 ng, the OC4BA v3 program will not help you.

 

OC4BA v3 only supports PMDG B737NGX, B777 and Aerosoft AB 318-321. Soon also the PMDG B747v2 when it is released.