Hello.Is anyone else having a problem with the Fly Tampa KSEA AFCAD file? It seems that after landing on 34L the AI planes try to take taxiway K but get stuck just after pulling off of the runway. They never move again until they actually disppear.This seems to happen with each version of their product (animated cars, ground vehicles, both of those & none of those).It gets so bad that the aircraft actually get backed up out onto the runway.

yes, same problem here, I posted this in flytampas forum and the answer was, either they get stuck off the runways, or get stuck on the taxiways. Personally I'd rather see them get stuck on the taxiways but so far nobody has made a good afcad for it. There was one in the library here but had a few errors that causes the afcad program to crash.Check out aitp10.zip here in the library, it will at least stop the 5 minute disappearing and you can adjust the time to your liking. Best addon ever!!

I think I found the file in the library you are referring to because I too get the crash with the AFCAD program. It does stop the backup problem though. But, I only got it when trying to access the parking through the menu. I found that because the way the parking is set with it isn't the greatest. I deleted some of the areas where UAL was being sent as it isn't correct. I haven't done anything else with it though (yet at least).I too posted a message in FlyTampa's forum but was getting a rather rude respose so I thought I would try here.