Hello,I have really strange problem. When I'm in VC, I can moving my head in all directions (yes, that's normal). But when engine is running and I increase throttle, then view is reseting immediately to directly forward. But in horizontal axis only.For example, engine is running at idle RPM. No problem, panning in VC works normally. I pan my view to the right. Still OK. Then I move throttle slightly forward and.... view is reseting direct forward.At this moment I'm trying to panning over VC, but it looks like a battle between my try to pan and someone, who's pushing my head direct forward.When throttles is back at idle, panning works fine again. This is not a problem in one specific aircraft, but in all aircrafts in FlighSim, so thats have to be some internal FS problem.Deleting of FS9.cfg, fsuipc.ini, clearing of key assigments doesn't helps. Disconectings of all devices like GoFlight, CH Flightsim Yoke, pedals etc. doesn't helps too.Does anyone has this problem? Any advice? Many thanks for any ideas.Michal Salek.

Micheal,It would be extremely helpful if you would mention what hardware you are using that is producing these effects?Are you using 'TrackIR'?

Check your key/axis bindings in FS9/FSUIPC.It sounds like you have something mis-mapped. Since you're using your throttle axis, check that.

Hi,thanks for reply.At first, I don't have any kind of Track IR or similiar HW.I'm not using Active Camera or similiar SW.Reseting also appears when all devices are disconecting.I'm using Go-Flight TQ6, CH FlighSim Yoke and pedals, but all these devices are mapped correctly. And as I wrote, disco of these HW doesn't help.I need to say, that I'm 90% sure, that this problem appears, when I'm deleting all keyboard assigments from FS. Really strange.Michal.