January 27, 20197 yr Hi all, I am using the Alberto PA38 and i keep losing control of my control surfaces. The yolk is turning but when i look at the surfaces they are not moving. The trim also moves around without touching it. It seems to be an intermittent problem that sometimes happens on the ground, other times when i am flying. I have turned off damage in the p3d menu to see if it was that but it still happens. there are no failures either. Any advice?
January 27, 20197 yr 13 minutes ago, samsee230 said: Hi all, I am using the Alberto PA38 and i keep losing control of my control surfaces. The yolk is turning but when i look at the surfaces they are not moving. The trim also moves around without touching it. It seems to be an intermittent problem that sometimes happens on the ground, other times when i am flying. I have turned off damage in the p3d menu to see if it was that but it still happens. there are no failures either. Any advice? calibration? had similar issues but after looking for what each axis does it's fixed now My system specs: Core 2 quad Q9650 @ 3.51ghz, GTX1060 6gb, 8gb ddr3 1333, 1Tb seagate barracuda, 500gb wd blue
Archived
This topic is now archived and is closed to further replies.