A320 baro reference

[Gaz 15]

Hi

This is regarding the Aerosoft P3D A320.  When I'm coming in to land, if there is a problem with the weather and the "baro reference" is not remaining still, then the copilot doesn't seem to move on - and it therefore useless - it just repeats itself.  Is there somewhere I can set the barometric's, then I can get the copilot to move on on the checklist.  Having said that, it's not on a checklist, it's just like it's saying that it's not to do it's job any more.

Thanks, Gaz

[williebarry1 4]

3 hours ago, Gary McCluskey said:

Hi

This is regarding the Aerosoft P3D A320.  When I'm coming in to land, if there is a problem with the weather and the "baro reference" is not remaining still, then the copilot doesn't seem to move on - and it therefore useless - it just repeats itself.  Is there somewhere I can set the barometric's, then I can get the copilot to move on on the checklist.  Having said that, it's not on a checklist, it's just like it's saying that it's not to do it's job any more.

Thanks, Gaz

press B.

[Gaz 15]

I've been using this software P3D/MFSIM for over 20 years, and you think I don't know what the B key does?

Well I hope you got laugh from that.

When I press B, it quickly rolls on up or down - it never gets to it's correct pressure, or if it does, it just continues rolling on.

[Gaz 15]

Any help?

[roesti 71]

Check the following:

- All 3 Altimeters (Captain, FO, Standby Instrument) are in sync / have the same QNH/altimeter setting
- The Altimeter / QNH setting on the APPR page (MCDU) is the same you've set on the altimeters
- The TA and TL (Transition Altitude / Level) are correctly set. TL is on the APPR page as well
- Your Ingame-Weather (don't know if you're using ActiveSky or something else) matches these settings

If you're correctly set up, I guess the Checklist should continue. Maybe provide Screenshots from your FCU with the Altimeter Settings, Standby Altimeter and MCDU APPR page if your problem continues to exist.

Edited August 20, 2020 by roesti

[Gaz 15]

Hi, sorry I didn't reply earlier - I'm not at where my P3D machine is. I'll give it another go with your advice in mind.

I appreciate you getting back to me.

Gaz