Am I alone, who now can't fly the B787? :-)

I was fly B787 no so often, but now i tried it. I set only 25% of fuel and about 70% of payload. I set speed for take-off according to FMC and fly. Take-off was ok, climbing not so quick, as expected, but I reach FL270 as I wants (only short flight). But if I was in approach, I select flaps 25° and 163kt in the FMC for landing. And if I gradually extended the flaps according with the FMC, then the landing gear, the plane was not able to keep the desired speed. It slowed down until the speed was just above the stall and then the stall protection lower the nose and plane was in permanent descend about 1000ft/min. So there wasn't any chance keep the plane in horizontal path even with engines run on 100%. I tried disconnect AP and A/T, but still wasn't possible to stabilize vertical path and reach the G/S and airport. I hit the ground about 2NM before the runway treshold. I think, that ASOBO was disproportionately decreased the engines thrust of the some jetliners (I tried only A320NEO and B787), because there is a very slow climbing of the A320NEO after update too. Is it only my some mistake with plane control or ASOBO disable jetliners for the Christmas? 🙂

Edited December 26, 20205 yr by ludekbrno