March 10, 20215 yr Hi, I'm now using Prepar3D V4.5 and also using PMDG B777-200LR/F, B777-300ER, B777-200ER. 2 days ago, I flew from Amsterdam to Indonesia with B777-300ER. But in all of sudden, I got a two message on my EICAS and I lost both of my engine control. 'ENG FAIL R' and 'ENG FAIL L'. Because there were plenty of fuel, engine didn't turn off but I lost my thrust almost to idle. Even though I control my throttle in manual, thrust doesn't work at all. I could see the throttle in 777 changes as I control my throttle but no actions in EICAS. And yesterday, I did same flight in same route and same plane, then it crashed at just same place(above New Delhi, India) 'again'. Is this a problem with scenery?(But I don't have any add-on scenery in India.) I also send a ticket to PMDG about this problem but they said that they have not heard of this problem too. I did the full removal and clean installation but no difference. I use FSUIPC6 free version and I didn't set axis about mixture at all. I also checked 'Enable automixture'. I think this problem occurred after PMDG 777's recent update. Is there any solution for this? Thank you Sungyoon Lee Edited March 10, 20215 yr by Sungyoon Because of full-name
Archived
This topic is now archived and is closed to further replies.