WT G3000 Flightplan problems.

Good morning,

Since i got no response in their Discord, i'll try my luck over here.

With the current Version 0.7.1. of the WT G3000 i am encountering an issue where the Flightplan does not (or extremely late) switch from the current target waypoint to the next in the active flight plan. While the plane still flies the planned route it the G3000 does not proceed which leads to unreliable distance and time readings.

Example:

Waypoint A is overflown and the plane turns to waypoint B while the GPS still shows the preceeding leg towards A with increasing distance to A. Sometimes it switches to B at around half the distance bestween A and B but not always.

I am not sure but i think this problem starts after using a "direct to".

Anyone else here who has seen this?

Best regards,

Tom