October 17, 20214 yr Hi everyone Recently I have begun developing a 3d printed mounting system to attach a phone to the front of the yoke. This is because I wanted to have my charts displayed on the yoke via avare. So far I have made an initial prototype and it has worked quite well. There are no holes that need to be drilled as it mounts to the 4 screws on the front of the yoke. Stock screws are still used. Current design supports a nexus 6P but depending on interest I could release it for other phones as well. File will be released on thingiverse once I make adjustments to the phone holding portion. Any feedback would be greatly appreciated
Archived
This topic is now archived and is closed to further replies.