Elevator axis and Engine 1 axis inexplicably linked

So randomly after a crash the elevator axis and engine one are now somehow linked.  I'm using the Saitek pro flight yoke with the throttle attachment.  I've double checked my joystick assignments and the elevator and and throttle are assigned to two different axis (Elevator to Y axis, throttle to X rotation).  Yet when I start a flight and push the yoke forward and back to move the elevators, engine #1 throttle jump to 50% and then goes back and forth with the yoke, despite not being assinged to that axis.  I tried changing the USB port it was plugged in to and deleting the yoke from the controllers and re-installing it, but the problem persists.  I had a similar problem with the Y axis on my CH throttle quadrant that I cannot use anymore because of it (throttle 1 assigned to the axis jumps right to 50% the moment you move it forward).  Whenever I go into the calibration everything appears normal as well.