I have run into a couple of problems while setting up the rudder and elevator trim controls in FS. When assigning the rudder controls, I selected right rudder trim and then start scanning. while in scanning mode I moved the wheel forward and it registered Number 9 as expected I then hit validate and repeated the procedure for left rudder trim and it came up number 10. So far so good. I I then selected apply and save but in the sim nothing happens when I move the rudder trim wheel.

Also when it comes to the elevator trim set up I can't seem to find an option for setting nose up and nose down trim. All I can find is either toggle elevator trim or set elevator trim, each of which only accept one input. so how do I get it to accept one input for nose up and another input for nose down? Any help on these issues will be gratefully received. I should also point out that both trim wheels have been properly calibrated.

Edited December 29, 20214 yr by stewartforgie

Check the SIM assistance settings. If those are set EASY, the SIM overdrives your adjustments (= auto-trim).