Limited Yoke Range - MSFS2020

[c0p0ut 0]

When pushing the yoke (XPC) forward and when pulling it back, during the last inch or less of travel, the simulator graphic and function snaps it back to center.  When returning the physical yoke to center, and after clearing the last inch or less of travel, the graphic and function of the yoke returns to normal.

Windows 10's control panel shows full range function, with no snapping positions.  MSFS2020 sensitivity page also shows no problem.

How can I fix this?

HoneyComb Alpha - Forward and Backward Range Problem

Edited December 19, 2023 by c0p0ut

[c0p0ut 0]

The problem has been resolved.  After confirming the yoke worked in FSX, I went back into MSFS2020 and noticed my Saitek x56 flight stick was plugged into a USB port on my computer and registering in the settings of the simulator.  After removing the USB plug, I tested the Honeycomb Alpha in both a single and multi-engine model, and it was working as it should with the full range of motion.