Hi,I have installed a combi of FSGlobal (Mesh) and USA-Roads & Water of Raimondo Taburet.I experience on a lot of locations sloped water like on the picture below.Is there a way I can solve it myself, or is it just something I have to live with? (which I don't mind, it's not a big problem)Also is there a specific order in which mesh/roads/water have to be layered?Right now the priority is as follows:Roads - 115 (Most prio)Water - 114Mesh - 113Thanks for your help,Egberthttp://www.scandinavian-va.net/upload/ksea.jpg

Dear Egbert;hi - and good day.Sloped waters can flattened by flatten switch - to cover that area.Steve Greenwood Fsplateen application to setup flatten switches can be very useful in this cases - as you flatten the exact lake coverage at@http://www.fs-traveler.com/cgi-bin/fstutilities.zipnetherless - and even said so - setting lakes on the right altitude where is needed is part of the version 1.1 update for usa water package - and that process will start from there - and will go on gradually till all waters polygons are right set.raimondo

Hi Raimundo,Thanks for your prompt answer!