Using AFCAD 1.3.2, I adjusted one taxiway (for a simple start)in the zzsfkdfw.bgl file by SimFlyers for KDFW. The reason is that AI traffic (I believe these are some that I installed from PAI) keep taxiing in the grass. I adjust the taxiway to line up with my aircraft. However, after restarting FS2K2 and it reindexes things, the AI aircraft just seem to move over and taxi in the grass exactly as before. They seem to ignore the taxiway line that I edited with AFCAD.I thought that AI aircraft followed these cad lines, the width of which is not a factor.Anyone experience this or have a suggestion?ThanksJayhawk

Those planes are apparently not taxiing using your file in the zzsfkdfw.bgl file, but are probably using the default dfw file instead. I don't have this airport - are you supposed to remove a default bgl file as well, or is the simflyer's airport given a different code than KDFW?Hope this helps,-- Tom GibsonCalifornia Classic Propliners: http://www.calclassic.com/Cal Classic Alco Page: http://www.calclassic.com/alco/Freeflight Design Shop: http://www.freeflightdesign.com/ San Diego Model RR Museum: http://www.sdmodelrailroadm.com/Drop by! ___x_x_(")_x_x___

Thanks, Tom. Good thought. The recommendation from SimFlyers was to use their AFCAD file to fix things and delete their KDFW bgl file (zzsfkdfw.bgl). I tried this, but it did not work the first time. I'll try it again. Maybe I didn't get it right the first time.Thanks,Jayhawk

One more thought - if you have made any backups of these files, make sure that they do NOT end in .bgl or they will be used by FS!!Hope this helps,-- Tom GibsonCalifornia Classic Propliners: http://www.calclassic.com/Cal Classic Alco Page: http://www.calclassic.com/alco/Freeflight Design Shop: http://www.freeflightdesign.com/ San Diego Model RR Museum: http://www.sdmodelrailroadm.com/Drop by! ___x_x_(")_x_x___