el_capitan

I have the same situation (PFC-throttle). For manual control I have to switch off A/T ARM. In autoflight everything seems to be ok.

Rudy Knott

The autothrottle seems to be very sensitive. I always have to switch off A/T ARM to be able to use manual thrust (PFC-throttle). If I don´t do this the levers are jumping up and down.

I think that according to the tutorial it should be possible to use manual thrust with A/T ARM on.

Rudy Knott

Hi Tom, What I use is just called "Two engines throttle" with spoiler and reverser. No special NG. In my case the flap lever is just a switch on the console. It seems to work like F6 and F7 on the keyboard. Unfortunately this doesn´t work for the gear switch. Rudy

Hi Tom, I have the PFC quadrant too. The lever for the spoilers and the landing gear aren´t working. Thrust and flaps are doing well.Let´s hope there´s some solution. Rudy Knott

Where are the knobs to tune ADF2? There is only on the captain´s side a possibility to tune ADF1. On the EFIS Control Panel there is a switch to select ADF2 on the PFD. Is this not ment to be used? Thank you for your help. Rudy Knott

Same problem here. Can´t install any livery. I tried to allow writing but in the properties it´s already allowed. Nevertheless the NGX is wonderful to fly. Rudy

Phil-Pull a copy of the SouthAfrican Airlink and tell me if it gives you the same problem or not?/

I can

I experienced it again. With the first plane loaded. In the outside view I could see that the left elevator didn

I just tried what Rhett said. I loaded the MD-11 and checked the elevator and the display worked. :-)This is a little strange for me because I always loaded the MD-11 as first plane. I

I have the same issue. Outside the elevator moves very well. It

Is it possible that the tower in the map is not available anymore? This would be very disappointing. ;(I just started to like FSX. Well the "help" says it is still possible but after several days of searching I didn

>also lets not forget the way you could just right click>anywhere on the screen to set the tower view position for nice>replay angles!...or the way you could see the cockpit>vibrating around you as you roll out at speed for take>off...and yes, saving the views on the fly..these were my 3>favirote reasons for using...and now missing active>camera..the fsx cameras are an improvement over default fs9>cameras...but its nowhere near as good as AC and never will>be.>>>DaveHow can I set a tower view position with a right mouse click in FSX? The only choices I get are other airport towers.:-zhelp

I`m missing the tower in the map. Is there any posibility to position a fixed outside view?el_capit

I don

Word Not Allowed is right. The noise appears only when you come close the stall speed. If the speed tape reaches the yellow line you hear this strange loud crackling honk noise. Now it

I installed the patch already yesterday.After 2 hours of testing I didn