el_capitan

I have the same situation (PFC-throttle). For manual control I have to switch off A/T ARM. In autoflight everything seems to be ok. Rudy Knott

The autothrottle seems to be very sensitive. I always have to switch off A/T ARM to be able to use manual thrust (PFC-throttle). If I don´t do this the levers are jumping up and down. I think that according to the tutorial it should be possible to use manual thrust with A/T ARM on. Rudy Knott

Hi Tom, What I use is just called "Two engines throttle" with spoiler and reverser. No special NG. In my case the flap lever is just a switch on the console. It seems to work like F6 and F7 on the keyboard. Unfortunately this doesn´t work for the gear switch. Rudy

Hi Tom, I have the PFC quadrant too. The lever for the spoilers and the landing gear aren´t working. Thrust and flaps are doing well.Let´s hope there´s some solution. Rudy Knott

Where are the knobs to tune ADF2? There is only on the captain´s side a possibility to tune ADF1. On the EFIS Control Panel there is a switch to select ADF2 on the PFD. Is this not ment to be used? Thank you for your help. Rudy Knott

Same problem here. Can´t install any livery. I tried to allow writing but in the properties it´s already allowed. Nevertheless the NGX is wonderful to fly. Rudy

@RobertThe south african airlines livery seems to work without adding the slash. :( Rudy

I can

I experienced it again. With the first plane loaded. In the outside view I could see that the left elevator didn

I just tried what Rhett said. I loaded the MD-11 and checked the elevator and the display worked. :-)This is a little strange for me because I always loaded the MD-11 as first plane. I

I have the same issue. Outside the elevator moves very well. It

Is it possible that the tower in the map is not available anymore? This would be very disappointing. ;(I just started to like FSX. Well the "help" says it is still possible but after several days of searching I didn

>also lets not forget the way you could just right click>anywhere on the screen to set the tower view position for nice>replay angles!...or the way you could see the cockpit>vibrating around you as you roll out at speed for take>off...and yes, saving the views on the fly..these were my 3>favirote reasons for using...and now missing active>camera..the fsx cameras are an improvement over default fs9>cameras...but its nowhere near as good as AC and never will>be.>>>DaveHow can I set a tower view position with a right mouse click in FSX? The only choices I get are other airport towers.:-zhelp

I`m missing the tower in the map. Is there any posibility to position a fixed outside view?el_capit

I don