fretei156

Thanks to all of you.. The problem was the xpx version, tore

Hi, Thanks for the answer, but stil no success, Numlock is on, I select my view, and presses ctrl+1 reverts to another view, tries the the 1 key but nothings happens Have also tried with different planes ex default barron 58 Perhaps a re install will fixit ...

Hi folks. Thanks for a lot of good information.. I especially liked the Whenever I get a new plane, the first thing I do is set up the custom view system. You find a certain position in the cockpit you like, say a pedestal view for example, then save it by presing CTRL+(number from 1-9). Then to go to that view, just press the numpad number you selected for it. I did this with my Carenado planes with the view system panel, I clicked on each view then saved it like how I described above. Now I just have to press one key instead of opening the panel So I tried this, but with out any big success I opend the panel, selected pedestal, pressed ctrl+1, (tried this vith both the upper and numpad numbers), closesd the panel, and tried the Ctrl+1 numpad, but no go.. Do I need a plugin or something,Using "clean " xpx, The only thing i have set up is the stick and throttle.... tore

Hi community. Have for many years flown around in fs9, and the 2d cockpit, but have now stepped over in the x-plane 3d world. and I have a cuple of questions in that regard. First: Can anyone tell me the best way to navigate around in the cockpit, I use the saitek x25 system, and have toyed round with the hat switches, but Im not totally satisfyed with the motion, so i could use some help. secondly Have also treated me with the Carenado C90B King Air as a bonus this year, a grate plane, but have you figured out if I there are any shortcuts to select the different areas of the cockpit, , or do i have to open the control and select the area from the panel and then X it out .. Best X-mas wishes Tore

Hi.Been using the PMDG products for some time, but only in 2D with 4 monitorsnow with the 737NGX I will try the VC /3D ..and got a cuple of questions. How is it possibel to use multiple monitors i 3D or can't this be done ??Or is it better with one large sentral monitor 30 / 40 inch tv ?? tore

Hi Have been flying pmdg for a while, but only in 2D, with 4 screens.Now I have bought the NGX and are trying to use the VC mode.. Anyone got a tip on the best screen configuration for this, cant figure out how to split the vc on more than onescreen. Or is the solution a 30-40 inch Tv ?? Tore

Hi After reinstalling the 737ng I'm not alowed to change the vfr, or nav freq's I get the + and - but the digits dont change..everything else is working fine..Anyone had this problem ??tore

Hi..YES that was the problem..Thankstore

Hi..I'm using FS9 and PMDG 737, Before takeof I sometimed get the message A/T fist, and the A/Tcant latch.I'm using the same startup procedure all the time, but gettingthis error only once in a whileIt seems that restarting the Fs helps but Im not shurecan someone please explain this..tore

Hi.Is it possible to save the a ongoing flight including all FMC entereddata ??It seems to me that all FMC data is cleared when saving the flight..tore

Hi just bought and installed the 737-600/700 pack.Problem when pressing ex the o key to get up the overhead panel the panel comes up ok, BUT when trying to close it the bottom half of the screen goes black, this also happen whne trying the Z key, The F(FMC) works fine ?? does anyone have any ide on this problem in the 747 it workes fine..tore