Bratwurst22

Hi Andrew, OK - got it. the Trim was assigned via the standard Flight Controls in MSFS. (ELEVATROR TRIM UP (NOSE up) -> no showing in the MCP Display. now assinged via LINDA - JOYSTICK Button (PMDG PED ELEV TRIM up) -> now showing the TRIM in the MCP Display. perfect. THX. Stefan

Hi, maybe it´s possible to show the trim in the mcp2 Display? Stefan

Hi, FSUIPC is killed after seconds. There seems to be a problem in the action.lua. here the last entry in the FSUIPC7.log 20656 LUA.4: [START] file_exists linda/system/init.lua 20938 LUA: "C:\Users\MSFS2020\Documents\FSUIPC7\linda/system/init.lua": killed 38031 *** LUA Error: ...cuments\FSUIPC7\linda/aircrafts/PMDG 737/actions.lua:3640: attempt to call global 'PMDG_LOGO_off' (a nil value) any advice for me? THX.

Hi all, Using LINDA 2.9.3 and FSUIPC 4.964 under JOYSTICK SETUP i have 2 Joysick: JetMAX 737 Throttle and SAITEK Yoke under SETUP LINDA -> SAITEK Panels is "unchecked" When both Joystick are enabled, the Buttons of the SAITEK Yoke are not avaible or working. Only the JetMAX Throttle is working. When uncheck the JetMAX 737 Throttle - the SAITEK Yoke is avaible and is working perfect. (Trimming up/down, etc.) It seems that they have a conflict working both site by site. Now i try in to "uncheck" the JetMAX 737 Throttle - and let the SAITEK Yoke as "checked" -> Pressing SAVE - and get the Message "OK!" When i start LINDA now again -> both Joysticks are still "enabled". is this a bug? - or do i something wrong. Thanks Stefan

Hi, thanks for your reply. Hope i got the right information for you. The CDU is listed as "Interface IT Controller" in my Device Manager. i found the following Info´s (Hardware-ID´s) HID\VID_1FD1&PID_03EA&REV_1033&MI_01 HID\VID_1FD1&PID_03EA&MI_01 HID\VID_1FD1&UP:0001_U:0000 HID_DEVICE_UP:0001_U:0000 HID_DEVICE also found that Info: USB\VID_1FD1&PID_03EA&MI_01\7&15a99fb3&0&0001 are these the expected Informations for you ? STefan

Hi, i got an error Massage "Error enumeratin HID Device" Using LINDA 2.6.7 Device Name: JvHid Controller Class Device Product: Complex Interfaces Device Vendor: TEKWorx Limited Device Name: JvHid Controller Class Device Product: Plain I/O Device Vendor: TEKWorx Limited Device Name: JvHid Controller Class Device Product: Device Vendor: RANGE CHECK ERROR i am using the Flightdeck Solution CDU for the PMDG 737 NGX. (Drivers from this site: http://www.tekworx.ca/downloads.php%C2'> when i disconnect the USB-Cable from the Device - >Linda discovers my Saitek Yoke & Rudder - and works fine. any help? Thanks Stefan