Tilly

My last post seems to have failed . Any way the problem is solved I had multi layers of yoke and rudder assignments loaded, it took a while to cleaned them all out but all now works correctly Many thanks to all who helped me with this problem much appreciated

The problem is solved :smile: it was my Saitek -yoke and rudder peddles Basically without going into a long explanation I set every thing back to scratch and started all over again and after a lot of fine tuning all is OK A big thank you to all those that replied ,the suggestion about key board commands triggered the grey matter

I use a Saitek pro flight yoke system and rudder bar I have checked that but will have another look, AS for FS9 cfg key board commands not sure where they are

I definitely have the FS9 version loaded, I have tried different airfields and surface textures , The same happens at all locations and surfaces- open throttle a/c rolls shut throttle and let a/c stop without brakes, open throttle a/c rolls this time stop with brakes , a/c will not move . So the problem seems to be the brakes will not release The aircraft file has this for brakes [brakes] toe_brakes_scale=1.0 parking _brake=1 differential_parking_scale=1.0 I have to admit the above means nothing to me (thick as three short planks) :-) .

OK I deleted all of Mr Kristensens files and downloaded the HP Hastings from Avsim and reloaded it into FS9. Opened throttles commenced take-off run shut throttles and let a/c come to a halt without applying brakes opened throttles and a/c started to move as normal , shut throttles and applies the brakes opened throttles nothing a/c would not move. So clearly the not moving again is linked to the brakes. Not being a PC boffin I don't have a clue what to do, I have a very basic knowledge of what goes on in computers , I am an old pensioner from the little black book and pencil age :-)

I installed from scratch the funny thing is quite a while back they worked fine but I had a problem with my PC and cleaned it out of all add on files . Then I reinstalled FS9 and when I did a fresh install the problem occurred . I down loaded from Simviation I think I delete all three a/c and down load from avsim and see what happens .

OK what is the problem, because as far as I can see they work ok with other people, and frankly I have not a clue where to look

Yes I should have said all other aircraft work 100%

Good day Gentlemen I have reloaded my FS9 and added aircraft from the Jan. B. kristensen stable i.e. Handley Page Hastings and Hermes and Douglas C124 , Every thing is fine until you stop moving on the ground ,Runway or taxy way, all three refuse to start moving again even with full throttle applied, I have contacted Mr Kristensen and he has never heard of this problem . I can not find any thing obvious in my set up .,my operating system is windows 7 64bit Richard woodard

Hi I would have replied earler but i had log in problems . Loading the scenery with PC in safe mode worked OK , thanks for the replies RW

Hi After loading Horizon's photographic scenery into FS9 with no problem at all i am now having a problem reloading into FS9 . When i try to reload after following the on screen instructions i have nothing in the add on scenery file in FS9 but all the files are loaded into the programs file on my "c" drive ok . I have tried all i know to get this scenery into FS9 with no luck , all three volumns loaded into FSX with no problem