jjvini

Hi, Where are the FSX PMDG 737/800-900 NGX? Can't find In the PMDG page! Only for FS9 Regards

Hi Folks! Some reason I solve the problem. The problem is FSUIPC. I remove and the Fuel Flow is ok, Just don´t me ask why? If anyone knows the reason I´m curious Thanks

Yes, Yes, I turn off the L & R packs and turn on when the both engine started. Thanks No, I don´t expecting to star move under idle thrust. When a apply thrust, a warning sound star and the aircraft don´t taxi. I watching a youtube tutorial and the FF reaches 1.56 and then decrease. Thanks

Hi, I notice that when I start engine (N2 > 20% and after N1 > 20%) the FF start and go 0,60 after decrease to 0,29 and stop. The egine don´t have power to taxi. (No ground conections) What am I do wrong or mistake? Regards Rezende

Yesterday watching a tutorial, I noticed that the Fuel Flow reaches 1.54% to start the turbines, I just got my 0.54%. What am I forgetting or doing wrong? thank you Regards

when i start the engine (no dark and cold panel) Fuel flow indicator is 0.0 - What am I do wrong or forgotten? All procedures APU etc etc etc is Ok. Regards Rezende

Hi, I execute all procedures to startup 737ngx (FSX) NO dark and Cold panel, but don´t have fuel flow. What am I my mistake or forgotten? Thanks Best Regards Rezende

Thanks to all of you! I will try the steps and I will read the manual. Regards Rezende

Hi Folks, thanks for the patience! Maybe I did not express myself very well. Below a short summary of my procedures: Engine is on. APU on, GEN left and right on. Beeld air on, packs off, I turn engines off (fuel cutoff). AES start boarding, 10 minutes that process. Boarding complete. Close door. Engine 1 and before 2 start, switch GRD, n1 > 25% fuel on. When I turn off the pack bleed and the APU, the duct pressure below 10 psi and the N1 = 20,4%. I can´t move! What I missing to do? I need conect external power too? Regards Rezende

Hi mullvadden83, I follow all checklist procedure. How procedure do you use to RESTART the engines? Thanks! Rezende

Hi I bought 737 NGX FSX (Windows 7 Ultimate) few days ago, and when I RESTART (NOT DARK AND COLD PANEL) the engines, the Duct Pressure is below 10 psi. I am AES user, so I don´t like to star the dark and cold panel. Can you tell me what I missing to do? or the Right steps to stop the engine and restart it correctly? Regards Rezende

Hi, I bought 3 days ago the 737 ngx FSX (Windows 7 Ultimate), and I stops the engines (not dark and cold panel, due I´m AES user), no problem at all. When I restart I follow the procedure like I do in Wilco 737-300/400/500. Engines on, but THE DUCT PRESSURE IS VERY LOW, and don´t have power. What the real procedure for stops and restart engines quickly? Someone can help me! Thanks Rezende