JazzyOne

Hi Kiek! No, I don`t use VR but set all VR-settings to off anyway to be completely sure that the default ai planes were disabled. 🙂 Regards J1

Hi again Kiek! I found the solution on another forum! I hadn`t disabled all the settings in MS2024 concerning default traffic. Like SkippingElk58 writes here i had to set the following settings to off: Settings-General-Online-Aircraft Traffic Type Settings-General-Graphics-Air Traffic Settings-General-Graphics-Traffic Airport Quality Settings-VR-VR Graphics-Air Traffic Settings- VR-VR Graphics-Traffic Airport Quality To be completely sure, one should re-disable to off on all settings if its already on off. Regards J1

Hi Kiek! I have checked the box User ground on the Collision Avoidance function, but when I approach other aircraft sometimes they disappear and other times don`t. It seem like it has something to do with the AI model. I am only using AIG models and have deactivated the AI-models that is included in the MS2024. Regards J1

After doing some experimenting, I might have found out about the problem. I have installed RealityXP 530 GPS gauge (2d) into my MU2. The alt sel capture and alt hold problem occurs every time I activate nav mode using this GPS. By staying to the MU2s GPS, or not using gps at all, the autopilot acts normal. Funny though that RealityXP cause this, I can use it on Flysimwares C441 without problem. Jan Ove

Yes.

Hi! I've read on the forum that other folks have experienced issues with the autopilots alt sel mode, saying that it sometimes works and some don't. The same thing goes for me. I do the following before use: - select altitude - press alt sel and vs - adjust vs climb rate I then activate the autopilot. The times it doesn't work the vs button goes off about 300 ft before selected altitude and the alt sel button changes from arm to cap. But trim doesn't move, causing the aircraft to overshoot target altitude. I trim it myslf and press alt hold to level out. I haven't found out what I do different when it work, but maybe I do something wrong... If so, please tell how it should be. But, and here is the next issue: The aircraft can't keep the altitude even when pressing alt hold. It goes up and down by 500-1000ft. Looks like the trim is struggling to balance the plane. I hope you Flysimware guys can check out if this is bugs to sort out! Regards Jan Ove