Stefan84

Ad 1. No, I don't. I use AS2012. TAT is ok (I know FSInn bug) Ad 2. No, all anti-ice are off. The problem has appeared some time ago. Earlier everything was ok and I've been thinking what did I do since then, what could cause it. Unfortunelly with no result. Maybe FSUIPC? But I've added there some nonlinearity in rudder axis, and nothing else...

Hello again! Thank you all for replies. It's nice to read that there is everything ok with my simulator, but... yesterday, I checked my N1 values one more time, and it was 47%! (after retard and established at "idle"). When the IAS reached programmed 300 knots, N1 didn't decrease and aircraft accelerated rapidly to 310 knots. Only after a while, I could decrease N1 by pressing F1. I ask you again - are you 100% certain that it is normal? I thought that N1 should decrease at the moment of speed changing from Mach to IAS, but you are the experts

Ok, thanks.

olli4740, I mean you are talking about N1 values, but thrust levers physically should be on idle position, and they aren't.

NM5K, in my opinion, everything would be ok, if the throttle come to idle in the moment of speed merging (as you said), but it doesn't. During descend, in the moment of speed merging, I am trying to force throttle levers to idle by disconnecting the autothrottle and pressing F1 key... then, after few seconds, throttle is going back to no-idle position. What is managing the throttle when the autothrotle is off? Is it normal? I don't think so.. Spin737, about 40-45% for both engines.

Hello everyone! I've noticed some problem with the thrust levers in my NGX. When I start descend in VNAV mode, thrust levers don't come to idle and stay a little above idle position. When I press F1 key, levers come to idle for a while and then back to previous position. As a result, the aircraft accelerate too much, and doesn't maintain programmed IAS speed for descend. The problem dissapear somewhere below FL300 (I don't remember exactly). The most strange is that even I turn off the autothrottle or change MCP mode to vertical speed, the problem doesn't dissapear and I suspect there is something wrong with my NGX or FSX, but I'd like you to make me sure before I start reinstalling software. Thank you very much for your replies.

Thanks. I understand it, but I don't understand why there is no alert, unless the alerts is a low pressure lights;) Besides it I did not touch the main pneumatic panel and pressurization panel, and everything was ok :) Sorry for my questions, but I'm inexperienced pilot, and these things are not normal for me :))) Thanks Tom, I will check it tommorow.

Hello everyone! I have just done a full flight (FL200) with all fuel pumps OFF. There was no any alert... Is it normal or bug? I have SP1c installed. Greatz.