nexe

OK did some flying. In flight plan approach has to be set on rwy that you want. But sometime that approach is different than approach that you see pressing the approach button on Map. And atc will insist on that approach no mater what. (Map fuction button approach). Only way that i will get promision to land on my rwy is to make sure that my rwy is sellected by checking that map app button. In that case i don't even have to request my rwy it is all ready given to me.

Iwill try this some time today and get back to you.

I tried different phrases, one was calsign, request full stop landing, rwy. Also tried callsign, would like gull stop landing, rwy. I tried using SayIt as well.

Hi guys, Didn't found information on this one. I am on p3d and "Forced pilot RWY" is checked. Flying VFR with filed FP with desired destination RWY approach. Flight is going smooth, copying clearance, ground, ( if i ask for different departure RWY it would be approved), tower, center. On destination approach if the winds are in favour of opposite RWY the i have selected, approach would tell me to expect oposite RWY and hand me to tower. Calling tower, i am requesting my RWY, request was understood, but tower is still coming back to me with oposite RWY. I can repeat request few times and every time i got same answer, sending me to oposite RWY. Tried this on fervdifferent airports with same results. What am i missing?

Hi guys, I hava a similar problem. P3D. Flying VFR with filled flight plan with rwy i want which is 28. On the approach, approach is tellig me to expect rwy 10, and hand me to tower. He is clearing me to land on rwy 10. After that i requst rwy 28. He comes back to me again with rwy 10. I have "Force pilot rwy selection" checked.

Thx Dave.

tjrush correct, but if l leave ATIS frequency on COM 1, and switch off my avionics, ATIS is still going on.

Nope, that's not checked. I tried to play with P2A provides ATIS and when not checked, no ATIS, when checked ATIS is on but with radios off as well.

I am in P3D and yes, voices are off.

Hi guys, Anybody knows why am i receiving ATIS with my radios off?

Just to add on this subject guys, I also have a problem with altitude verification. I would get warning about low altitude only if i use Auto Plan in IFR. Auto Plan in VFR is giving me a negative values for altitude. Thanks