dougduplessis

Has anyone integrated the GTN 650 into the 3d panel of a Vflyteair model such as the Arrow or Cherokee? Doug

I made a mechanical adjustment that moved the dead zone out of the center position. The pinion gear interface can be adjusted for each axis. I moved the spot where the gears meet while having the x-plane axis/centering page open to see the effect each slight change would have. The pitch adjustment was easier than the roll axis. Before my adjustment, there was about 0.5" of travel (pitching up) until the software would detect motion. After my adjustment, the dead zone is in a yoke pitch position that is not as critical and infrequently used. Same situation with the roll. Just moved the dead zone to a more extreme roll position. After making the change, just click to center on the new poison and/or recalibrate. After these changes, the response around the center position is immediate and I don't even notice the dead zones since they are in more extreme positions. Good luck!