Matt17Keane

I am using Active sky next, but I looked at the conditions at the altitude my aircraft was at and all the winds and turbulence seemed normal. I watched the autopilot disconnect from just being on Lnav and Vnav and the normal AP disconnect alarm went off (warning button was illuminated, as well as a notification next to where the engine n1 is displayed). Yes the FMA alerted me that the AP disconnected and I was able to bring the plane out of the roll and back on course using my yoke. Also, I was able to reset the autopilot, and it would fly anywhere between 15 seconds and a minute before disconnecting again. BTW, my full name is Matt Keane.

Just yesterday, I noticed that while on flying on a long haul, I had the plane on Lnav and Vnav and it was flying level. All of a sudden, the autopilot disconnects and the plane starts rolling to the right, as if i was trying to invert it. I tried re calibrating my yoke and reinstalling the drivers for it with no luck. I also tried doing a clean re install of the 777-200lr with no luck either. This has never happened before, and I have had it for about a year now. If it helps, i am using windows 10 and FSX steam.

Hi, When I open the FS2Crew config manager, I get an alert that says I need the service pack 1c for my ngx, but when I try to install it, it says that I have a later update, and that i'm trying to install an earlier version. Also, when I go to addons in fsx, it doesnt show up there. This problem pertains to the Special Bundle and the EmergencyNGX. Thanks for your help!

Thanks Robert! Hopefully this fix will work, but i just have one question. I have searched throughout fsx settins but couldnt find "auto rudder", if you could shed some more light on that, it would be great. Thanks!

Hi, I have the pmdg 777-200LR and the 300ER. I use a CH products flightsim yoke. Just recently, I have lost the ability to steer using my yoke (I don't use rudder to steer on the ground). The way I usually steer on the ground is by turning my yoke left or right (which is used for alierons), which would also make the nose wheel turn in the direction i was steering. For some reason now, when I turn my yoke, it activates the alierons, but doesn't turn the nose gear anymore. I have tried unplugging and plugging my yoke but that didn't work. Please help! Thanks, Matt Keane