tecno1

G-RFRY Thank you, very kind. I follow the suggestion.

Sorry for my poor English. I'm italian. I would like to purchase MFS2020. I currently use FSX. Having only one HD, you can also install MFS2020. Thank you

Good morning Dan, I did a test with a short flight LIPE to LIBD, in the image below during the taxi and everything is ok The second image after the T / C before saving the flight and everything is ok In the third after loaded saved flight and you see the modified RADIO data Finally the part of the .SAV file where the data that RADIO MINIMUMS appears is correct. At this point what should you do? Thanks for your time Lorenzo Pierantoni

Dan, sorry if I answer only now but I write, bad in English, from Italy. I found the file you wrote to me and the saved data was 19200. I changed to 10200, then reloaded the saved flight but now I see 9200. I'm sure to launch the simulator as administrator, however pro to make a new simulation then I write what It happens. For now, thanks. Lorenzo Pierantoni

For completeness, the value that is imposed is 200 feet

It would be the parameter relative to the minimum decision height during landing that I insert when approaching the airport

Save/Load from the FSX menu: You can also conduct save/load operations from the FSX menu. The PMDG 737NGX will intercept the save/load function and create both the FSX save file and the PMDG 737NGX panel save file for you using the name you select. You will then be able to load your flight and panel state from the FSX menu as well and the airplane condition will be just as you left it. This is what the manual says. When I load the saved flight everything is in the condition of when I saved it. Only the RADIO parameter, as shown in the attached picture, is completely incorrect. To correct the data it takes 10 minutes with the simulator paused. Is it a program error or what does it depend on? And how to solve it? Even if the Panel state is loaded by FMC, the RADIO data always remains as an image. The RADIO parameter sets it during the descent phase Lorenzo Pierantoni

I write from Italy and excuse my bad English.I'm passionate about FSX and use the 737NGX for offline flights. I have a small problem when I save a flight and then take it back at a later time in the moment in which I reload the RADIO setting instead of having 200 ft as set I always appears 9100. Therefore I am forced patiently to bring back the original condition.Everything seems to me incorrect. You have some help to give me. Thank you Pierlore