zwenna

Hope so too

I have similar situation here with 8600K. Core 0 100% but fslabs all cores around 45%. Were there any final Statements or resolutions here regarding OP.

Are you all tweaking with FFTF so that you have autogen trbl?

I went back to driver 397.93 but no test yet. Had good experience with that driver but on 4.3 and with a 1060. Now I have a 1080ti and 4.4. Will see.

Had a bluescreen too today. CPU could not hold the 30hz vsync. I also changed the driver.

Do you work with vsync on at 30hz?

Why do you have vsync on and limited to 27?

How about BN2 by Blackbox. You can try before buy.

@ShezA: Why do you set internal limiter to 30? How about unlimited?

I asked that several times. Why should ffts dynamic offer a setting of 0.01 if P3D can not handle it? This question is also valid for 0.02 and 0.03 and so on. Those figures can be Set in fftf dynamic.

Some users say that FFTF is automatically set to 0.01 if fps limiter is set to unlimited. So everything confusing here. One is saying 0.10 is lowest possible, one is saying 0.01 automatically if FPS limiter unlimited. What to believe?

I´m very interested in your Settings here guys and why.

Very confused right now. Anybody out there Who gives a little short summary for a guy like me.

Hi Ray, do you often switch between 30 and 60 hz. I am little bit afraid of it. Reason for switching is my wife got some problems with photoshop on 30 hz si I decide to switch do 60 hz in desktop mode and 30 when in P3d. Hope that these switches did not destroy monitor and or GPU in long term validation. Regards

Vsync and TB on? Regards