Jump to content

David Thompson

Frozen-Inactivity
  • Content Count

    4
  • Donations

    $0.00 
  • Joined

  • Last visited

Community Reputation

0 Neutral

Flight Sim Profile

  • Commercial Member
    No
  • Online Flight Organization Membership
    none
  • Virtual Airlines
    No

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi guys. Reading further into the bug forum I see that this is exactly the same bug I just ran in into. Unfortunately I am using 2.5.0.1 x64 so the bug is either not fixed as assumed or has reoccurred. I've made a separate post in the main forum but now realize it should have been here.
  2. Hi all, After studiously reading through the first 156 pages of the manual I installed Pilot2ATC successfully and set up as much as I could. I use X-Plane 11 and set up the P2A autopilot to help as much as possible. I successfully created a flight plan from Guam (PGUM) to Haneda (RJTT) and validated it. After some practise and learning of the voice recognition I successfully contacted ground for push-back etc and eventually handed over to the tower. On approaching the requested runway Holding point things started going wonky. P2A became sluggish and a bunch of my voice requests appeared bunched together after a minute. After another run through the ground to tower sequence P2A once again clammed up, this time permanently. I discovered there was a "P2A COM Frequency" pop up that was unable to be closed. Nothing on that pop-up or the main P2A window was ever clickable again. It appeared to have hard crashed. The whole time X-Plane 11 continued to run perfectly. Closing XP11 did not cause P2A to recover. This was my first attempt at take-off with P2A and the first step in my evaluation of the well, evaluation. I'm hoping this is either a side-effect of something I did wrong or an easily-fixed rare bug. I've included a screenshot of the P2A and COM pop-up if it helps anyone assist.
×
×
  • Create New...