knowlep

I want to uninstall V4 and keep V5 but I have the old PMDG 737, the new PMDG 737 NGXU and 747 in V4. I also have the new PMDG 737 NGXU and 747 in V5. I don't know whether they are linked in any way. Does anybody have any suggestions for the process of removing V4 completely without upsetting any PMDG plane installation?

In V5 I used to get a major STUTTER just before you get to the runway threshold ...however I've just reinstalled it again for another try and it seems to work fine....hip hip hooray.

I've also found that you need to disable auto launch in the old version as it still starts with p3d and tells you it needs updating. when I did this the new version launched with p3d from then on (assuming that auto launch is on),

I found that I ended up with both the original version which ran when I clicked my existing shortcut but also there was the updated version after migration which ran if I went to my start menu Chaseplane icon that referred to the new version in a different folder. I'm assuming I can delete the old folder but too scared to try that at the moment.

Oh didn't know that...I do not get any warning message.....cheers for the help.

Just wondering if anyone else is having the recurring problem that I am........I'm flying PMDG 737-800 NGX (in fact it happens with all the 737 variants) and I load up a fresh boot up of p3d and fly without any problems. The issue comes when I press escape and "Load Scenario" which is one I've previously created (doesn't matter which scenario the problem is in them all with the 737 ) and after the scenario loads and the 20 second re-coding countdown finishes the plane seems very tail heavy and no matter what I do it's constantly nose up, slow and tail heavy threatening to go into a stall. I can trim it out and fly it but it's not right and as air speed reduces the worse it becomes and you can't land like that...... but if I exit p3d and load that same scenario from a fresh it works perfectly??? I've tried all sorts like re-trimming before I switch scenarios but nothing works except a re-boot of p3d (not the PC). BTW I'm on p3d V4.4 and loving it. Any ideas.