claplata

Thank you for the answer. It was a zip file and I was able to extract it and get the download.

I signed up for the auto update notifications last month. I received a message when first turning my computer on yesterday, 1/14/2020, of the new GNS2 v.2.4.17.0. I clicked on it to install and it saved it, so I thought I was good to go. I turned on my computer today and the same message appeared about the same update. I clicked on it again, paying a little closer attention to where it was going, as saw that it is saving it to my documents folder. I'm assuming this is not where it should be to work properly. I went back to reality-xp.com/support/updates to read some more. I set up the RSS feed on my Internet Explorer Browser. I downloaded the update again through the RSS feed and this time it saved it to my downloads file. I don't imagine it's supposed to be there either. As you can tell, I'm not too computer savvy. Anyway, could you please tell me where it should be saved to work properly and how to properly do updates for the future.

Thank you, I was able to figure it out. I didn't realize the new RXP configuration options were in the joystick config options right along side the X plane config options for the GPS.

I recently purchased the G530 v 2 from RXP to replace the default G530 from the Cessna 172SP in X Plane 11. I have installed both the trainer and plugin and see the G530 listed as a plugin in X Plane, but I do not know how to configure the buttons on my hardware to control the RXP G530. I have a new Diagma simulator with the hardware for the G530. I had it working great with the default XPlane 11 G530. Do I need to remove the default X Plane 11 Garmin?