Andrew Whetton

Why is there an option to have either a left or right MFK/MFD and matching left or right keyboard minus the opposite side for the Qualitywings 787 CDU license.

Hello Andrew Thank you for the reply. The update does seem to take 1 sec per click, but I've since discovered that the same is happening to the PMDG777. Yes, for all rotary control knobs there are inc and incfast and dec and decfast etc etc for both QW787 AND the PMDG777. I was rather hoping that the default FSX functions were present but as is happening to the PMDG777 and its rotary controls functions have inc and incfast etc etc I am somewhat stumped. Regards Andy W

I have FSX QW787. VRInsight MCP1 the most up to date versions of Linda 3.1.1, the module for QW787 1.1 and FSUIPC 4.977 registered. My issue is, when I turn a rotary knob control, whether it be for SPD HDG ALT, there is a long delay before the numbers on the VRInsight display matches the QW787 display. I can turn the control so the figure advances rapidly but when I stop, the display on the QW787 is nowhere near what the VRInsight display is showing to the point where the VRInsight display changes to what the QW787 is showing. Annoying when I need to increase a value, say height, from 1000ft to 10000ft. I can get as far as increasing it to 1500ft on the VRInsight,......pause to get a better hold on the knob only for the VRInsight display to drop back to say 1200 because thats what is on the QW787 display. All that turning for a small increase. I takes an age to get both to match to my desired setting. Thank you Andy W

Having acquired the FS2Crew 777 I must say its rather good. But as the PDF says there's not much to do before TOD. Could future updates possibly have us more to do in between TOC and TOD. IE checklists, noting fuel usage and other in flight requirements. There's only so many cups of tea and sarnies one can consume. Regards Andy

AHHHH..Scot Thank you. That put me on the right track Regards Andrew

This is my setup where Linda is concerned VRinsight MCP ver 1 Linda 3.1.1.854 PMDG 777 module 1.5 FSUIPC 4.975a registered Once FSX is loaded and the PMDG 777 is selected the only switch that works on the VRinsight MCP is the F/D switch both on and off. It works the other way when I do mouse clicks on the PMDG 777s panel the result is reflected on the VRinsight MCPs display ie changing speed from 200 to 190 shows up as 190 on the VRinsight MCP. Trying to do it the other way, selecting speed 190 on the Vrinsight MCP does nothing on PMDG 777s MCP. Ive done clean installs of Linda and the PMDG 777 module and FSUIPC. I have the QW787, PMDG 737NGX and PMDG 747 modules and they work flawlessly. I just cant figure out why the 777 module doesnt work. Apologies if theres an answer in this forum but I cant see it.

FSUIPC autosave is the culprit for me