FoxToGo

When I start the plane from cold and dark and set the battery, ground power, the displays (pfd,etc.) are not turning on. When I load into the regular state, all of the displays are on. What can i do to fix this? https://imgur.com/a/Xeh9iKh

Sorry for wasting so much time. Thank You!

I figured out the problem, I just had SP1, so I installed SP2, from the offical Microsoft Website an then it worked.

I did remove the repaints, and I still have the problem. Now the problem is there even when I try to change the time and date.

So what can I do to fix it? I have no other AI installed.

How it looks when I change it back: https://imgur.com/a/OXCxdu5

Here is an image of my settings: https://imgur.com/a/djDV2U7

Just the repaints. The scenery settings is what I was talking about. If I set it to low scenery, the problem goes away, but it looks ugly for me. But if I crank it up to high, the problem is there. And if I change some of the little settings, like Anti-Alasing and set time to system time, the percentages change, but only by a bit.

OK i can confirm that did not work. Is there any way I can have good scenery with it not crashing?

I actually did figure out the problem. I only know how to fly a 737, so I want some livires on it as well. I got a 151 livery pack from the internet. When I deleted it then did the test, it worked completly fine. I also tried with only 1 livery, it it was fine as well. Now I will try to get a list of livires, and install them indivudally.

But even on older, worse processor and graphics card, does in just a couple of seconds. It also stops responding.

Someyimes I like to speed up the flight a bit becuase for me it it is too solow. (i am just an amateur). 4x is a bit too slow for me.

I just installed FSX on my brand new computer. AMD Ryzen 5, nvidia geforce gtx 1050 graphics card. I have tested this on another computer, and it works fine. The problem is whenever I change the Sim Rate from 8x or above, back to normal it gets stuck at loading the traffic. I have noticed that the problem goes away when I change the scenery to low settings. However, this is ugly, and I don't want to fly like that. Any suggestions?