Jump to content

Ape42

Members
 View Profile  See their activity

  • Content Count

    4

  • Donations

    $0.00 

  • Joined

  • Last visited

Community Reputation

0 Neutral

Flight Sim Profile

  • Commercial Member
    No
  • Online Flight Organization Membership
    none
  • Virtual Airlines
    Yes
  1. Ape42
    Thank you for this fast answer. The "More Details" is a good workaround for now. But if it would be possible to configure that I would be glad. 🤗 Anselm
  2. Ape42
    Hello. I changed from LNM 2.6.19 to 2.8.8. One "issue" is that the parking positions and taxiways are now displayed later than before. I have to zoom in quite more to see them on the map. I did not found a setting to change the zoom level from which on these items are displayed. Can anyone tell me if such a setting is available and where I may find it. At this sample I have to zoom in three more steps to see taxiways and parking positions again, which is too much, for my taste.
  3. Ape42
    I do have a very special issue with the PTT button and the Velocity One Flight Yoke. The special is that the V1F annouces itself as two devices with the same name of VelocityOne Flight: one is the yoke, one for the throttle Quadrant. I try to program the PTT button on the yoke. When opening the dialog I see both devices with the same name. But I have to select the correct one to have the buttons be detected. Only, if I select the second entry, the button on the yoke will be detected. See screenshot: But after saving this setting, I have to push the button number 8 on the throttle quadrant. Pressing the button on the yoke won't work. Question: Do you see a chance to handle a hardware setup like this and fix this issue? And of course: The logfile of re-programming the PTT button. I selected the second device (the yoke) and pushed first the button 9 and then button 8. Saved the settings. Afterwards I first tried button 8 on yoke, nothing happened. Then button 8 on the quadrant, PTT working.
  4. Ape42
    Hello, i am trying to control the light levers using the software Axis And Ohs. But i did not succeed. When writing to (>L:XMLVAR_LIGHTSWITCH_LOWER_INST_1_Position,·Number) i am able to move the lever, but the light does not change. Can you tell me what variables are needed to be set to have the light changed? I do need this information for AR flying where i use physical levers to control the lights. Thank you and best regards
×
×
  • Create New...