Jens Peter

Yes that's the reason, just in the real plane, Great ;O)

Hello Ark Thanks for your GREAT help, the solution to the problem was so simple :O= In all my planes the L+R tanks are filled equally normally around 50%, BUT not in this Bird. For an unknown reason the left tank was empty !, filling it up, everything is possible, I CAN FLY ;O) Would never had pinned the problem without your help, Thanks !

Great idea, so i did the re-name solution (did buy it at MP) and tested it. when loading at the rwy engines running all went fine untill i fired up, then the left engine immidetly died (all buttons very correct) When starting at a gate, the left engine stopped as before when turning the startkey (magneto) from startposition to Both. When re-naming the community folder no change :O( Further i did run some test og the default Beech Baron and King Air 350 and they worked fine, i was able to start up at the gate. Checked also the Caranados Beech D18S and no probs. Finally i have removed all magneto key bindings for my keyboard and other devices but no result :O( I think it must be a problem with the C414, since it didnt even help to unplug the Honneycomb Alpha throttle and only using the mouse, the L-engine was still dead. Once Again, Many thanks for your kind Help ;O)

Hello Ark, Thanks for Reply ;O) I Re-installed the plane Started at RWY with default Livery engine started config./honeycomb Alpha Yoke/ left engine refused to run It is possible to start from cold&dark, but when switcing the starter dial/key from R-L-Both to start position both start, but L engine stop again The Suctiongauge showed L/red/ No Rpm etc. Disconnected loaded same flight without the A-Yoke and with engines running config, Same Result ! Loaded Cold&Dark, started again, L dident start/R engine was running fine :O( No idea of what can be wrong, does anyone have the same problem ? And Thanks Steve, yes i followed the checklist so tanks was on L+R ;O)

Hello Noble Airmen I have encountered heavy probs when starting up the C414. I have no problems with other aircrafts,PMDG 737,PC12 etc. Following the checklist from cold and dark when starting engine 2 (left or right) engine 1 stop. The default autostart (ctr+E) dosent help, same result. Disconnecting the Honneycomb Yoke trying to start engines with mouse clicks give same result. I have gone through all joystick and keyboard commands so i dont have buttens assighned twice to the same command. Still no luck, dammed with problems with such a nice plane ;O( Any input are much appreciated.