Hi to everybody and thank you for this wonderful product!! :-jumpy I have a problem with the Lower EICAS: the screen in black. I'm NOT using the Side-by-Side EICAS. Reading the introduction manual I found the following lines: "Important Note: The lower display unit will only display data if you have selected either ENG or SYS from the lower DU selector panel located on the main panel". That makes me think that the Lower DU selector located on the mai panel should be working, but it's not clikkable.Any advice?Thanks a lot! :-wave

You have to use either of the two push buttons (ENG or SYS) located right above the EICAS.

HiThe lower DU selector panel is placed just above the upper DU. Two buttons marked ENG and SYS.Hope it helps,

Hi and thank you, I found it!! ;-)

On my panels (6/7/8/900) they're marked inop and don't do anything when you click 'em..I've tried the over/under and side by side eicas to no avail.Trevor LoweCYYZ Apron CoordinatorTerminal 3YYZTWCR

>On my panels (6/7/8/900) they're marked inop and don't do>anything when you click 'em..>I've tried the over/under and side by side eicas to no avail.>>Trevor Lowe>CYYZ Apron Coordinator>Terminal 3>YYZTWCRgotta be in the Virtual Cockpit version of the airplane, not the 2D panel.

Well no not really Tim he can have the EFIS STYLE in 2D with INOP too. Try switching to the PFD style..[h4]Best Wishes,Randy J. Smithhttp://www.precisionmanuals.com/images/forum/betaimg.jpgAMD 64 3200+ | ASUS KV8 DELUXE | GFORCE 5700 ULTRA @535/1000 | WD SATA 80 GIG | 512 DDR 400 |

User error again. :) I guess I'm not as scientific as I thought. I have to have over/under selected, and THEN press the buttons.. :) Got it working. Thanks!Trevor LoweCYYZ Apron CoordinatorTerminal 3YYZTWCR