Hi All!Yesterday I tried to set my V-speeds manualy using V-speed selection knob.I am able to select speed I wana change (V1 for example).PFD shows small green V1 80 near the bottom of speed tap, but I can't change this value clicking on the center (where hand is shown) of the setting knob.Am I doing anything wrong? Before upgrade to 800/900 it was possible to set Vspeeds this way.Thank you for answer.

Right-click increases the value.Left-click decreases the value.

Works here, at least from the 2D panel. Tried it at 1024 x 768 and 1280 x 960.

>Works here, at least from the 2D panel. Tried it at 1024 x>768 and 1280 x 960.>As far as I know, the only part of that knob that has an issue is when you try and set the weight it doesn't work quite right. Setting V-speeds works fine.

Yes you are correct Tim but in regards to the PFD display not on the EFIS MASI. Selection of WT with the selector will blank the PFD elements (BUG) and will be fixed..[h4]Best Wishes,Randy J. Smithhttp://www.precisionmanuals.com/images/forum/betaimg.jpgAMD 64 3200+ | ASUS KV8 DELUXE | GFORCE 5700 ULTRA @535/1000 | WD SATA 80 GIG | 512 DDR 400 |

Thank you very much for replies. It works exactly as you wrote, including VC. I didn't try the left click on it :-(, but I have read the manuel prior to posting :-)